Training held by JNMI

 

   

  • Training course was held in 20-24/3/2016 in “Quality Management System According to ISO17025”; the training was held in JNMI, three participants from Palestine following PTB project
  • In 10-12/5/2016 training course in “Uncertainty of Measurement & Introduction to Metrology”; five participant locally
  • training course was held in 15-24/12/2015 in “Calibration of Temperature Sensors”; the training course was held in JNMI for participants from Sudan
  • Training course was held in 20-24/3/2016 in “Verification, Calibration and Preventive Maintenance for Medical Equipment”; the training was held in JNMI, Ten- regional participants from Yamen, Palestine, Iraq, Lebanon, Egypt following PTB project
  • Training course was held in 10-13/1/2016 in “Preparing Testing and Calibration Laboratories for Accreditation to ISO/IEC 17025:2005 standard”, the training course was held in Kuwait
  • Training course was held in 31/8 – 6/9/2015 in “Calibration of Laboratory tools and Instruments” ; seven participant localy
  • Training course was held in 13-14/6/2015 in “Calibration of Electrical Measuring Equipment & Electrical Calibration”; the training course was held in Sudan
  • training course was held in 7-9/6/2015 in “Calibration of Temperature Sensors”; the training course was held in Sudan
  • Training course was held in 10-14/10/2015 in “Calibration of Temperature & Pressure Measuring Equipment”; five participant locally
  • Training course was held in 18-22/10/2015 in “Advanced Metrology Training on Temperature ”; ten regional participants from Yamen, Palestine, Iraq, Lebanon, Egypt following PTB project
  • Training course was held in 27-29/10/2014 in “Calibration of Mass Measuring Equipment ”; five participants locally
  • Training course was held in21-25/9/2014 in “Middle East Regional Metrology Training in Temperature ”; ten regional participants from Yamen, Palestine, Iraq, Lebanon, Egypt following PTB project
  • Training course held in 11-13/11/2013 in “Calibration & Verification of Mass & Balance Measuring Instrument”; Ten Participant Locally
  • Training course was held in 4-6/11/2013 in “Calibration of Temperature & Humidity Measuring Equipment”; four participant locally
  • Training course was held for 14 participant from Palestine for the following course in the interval 1-12/9/2013
    • In 1-3/9/2013 training course in “Uncertainty of Measurement & Introduction to Metrology”
    • In 4-9 / 9/2013 training course in “Training Course in Mass & Balance Calibration & Uncertainty Calculation”
    • In 10-12/9/2013 Training course in “Training Course in Volume Calibration & Uncertainty Calculation”
  • Training course was held in 27-29/5/2013 in “Calibration of Temperature Sensors,Ovens & Autoclaves”; twelve participants locally
  • Training course was held in 20-22/5/2013 in “Uncertainty of Measurement”; seven participants locally
  • Training Course was held in 28-30/4/2013 in “Calibration of Pressure Measuring Equipment” five participants locally
 
   
   
   
   
   
   
   
   
   
   
   
   
   
   
     
     
     
     
     
 
 


© 2006 JNMI - RSS. All Rights Reserved.